Understanding Scales And Scale Drawings A Guide The scale bar is a key component of scale drawings as it helps provide an understanding of distances depicted on the drawing. these scale bars show what one unit represents at different scales. scale bars will typically start at 0 m (or 0 cm, 0 km etc). however, in some cases they may start at a different value. What is the standard scale for drawing? referred to as 1:10, 1:20, 1:30,1:40, 1:50 or 1:60 scale. typically in civil engineering applications, 1:10 (1″=10′) is used exclusively for detail drawings. 1:20 and 1:40 scales are used for working plans. 1:60 is normally used only to show large areas of a project.
Understanding Scales And Scale Drawings A Guide 1:20 to 1:10. a more specific use of the 1:20 and 1:10 scales is to represent furniture. this is common for both architects and furniture designers to present the workings of the components and. Metric scale 1:50. the two scales shown are 1:50 and 1:500. what they represent is the following; 1:50 means that when you measure 1 cm on the drawing it is equivalent to 50 cm of the real item to be built. 1:50 is also equivalent to 1 2 of meter for every cm on the drawings, because 100 cm is equal to a 1 meter. We measure the bathroom in millimetres. say it is 3,600mm x 2,400mm (3.6m x 2.4m). we can try to convert from 3,600mm by dividing by 50, or we can use a scale ruler. we take our scale ruler and flip it to our 1:50 scale. we can see that 1000mm (or 1.0m) in real life is equivalent to 20mm (or 2cm) on our scale ruler. Here are some tips for accurately using an architectural scale: make sure the scale is placed firmly against the surface being measured. place the zero mark of the scale at the point of origin for the measurement. read the scale from left to right when taking measurements. double check your measurements before recording them.
Comments are closed.