How To Remove Chevy Transmission Cooling Lines Youtube Remove trans cooler lines without removing the bolt that grabs the line, sometimes there is a plastic ring around it so just pull it with a pry bad or screwd. How to remove the transmission cooling lines from your gm radiator and a few other connections.
Easy Gm Transmission Cooling Line Removal From Radiator Youtube Shop for new auto parts at 1aauto 1aau.to c 182 f transmission oil coolerstransmission cooling lines deliver and return transmission fluid between. The "to cooler" line from the transmission will be right up against the exhaust making it impossible to remove. after all four ends of the (2) lines are disconnected remove them. the lower line, which runs from the transmission to the cooler directly behind the grill, should be pulled through the front. the upper line, runs from transmission to. Out of the auxiliary cooler left side back to the transmission upper line. same style of connections on the transmission. slide the round black locking cover back to access the small wire retaining clip. remove the retaining clip and pull the line free from the fitting that is threaded into the transmission. Here are the steps you need to take to change your silverado’s transmission cooler lines: 1. jack up the truck and place it on jack stands. 2. remove the skid plate and the splash guard. 3. disconnect the transmission cooler lines from the transmission. 4. remove the old lines and replace them with new ones.
How To Replace Transmission Cooler Lines Like A Pro Car Part Out of the auxiliary cooler left side back to the transmission upper line. same style of connections on the transmission. slide the round black locking cover back to access the small wire retaining clip. remove the retaining clip and pull the line free from the fitting that is threaded into the transmission. Here are the steps you need to take to change your silverado’s transmission cooler lines: 1. jack up the truck and place it on jack stands. 2. remove the skid plate and the splash guard. 3. disconnect the transmission cooler lines from the transmission. 4. remove the old lines and replace them with new ones. Come right under with a little forkey tool or a screwdriver, lift up the center, and then you can lift up the outer portion. we'll do the same to all, this off of here. now, let's go ahead and grab onto these. give them a little wiggle, pull them right out of there. lift up your headlamp assembly. set that aside. If no oil flows out, with the engine running, slowly add oil at the top of the transmission until fluid begins to drip from the level check bolt; then replace it and close the filler opening. put the car back on the ground and enjoy your new transmission fluid. frankta2. like.
Comments are closed.