Finding Oil Leaks With Uv Dye Ej22 Youtube In this video i'll demonstrate how to use engine oil dye and a uv dye light to find oil leaks. be sure to use the instructions provided by the manufacturer. In this video, i show you how to find leaks using a uv detection dye. oftentimes, vehicles will have multiple leaks and it can be hard to locate a specific l.
Find Engine Oil Leak Cheaply Effectively Using A Uv Dye Detector In this video i show you how to check for oil and other fluid leaks using uv dye that you can purchase at your local part store. this is a great way of findi. Common spots to check are the oil filter, oil cooler lines if your car has an oil cooler, between the engine and transmission bell housing (rear main seal leak), and behind the serpentine belt and crankshaft pulley (front main seal leak). additionally, leaks may be visible from the top if the camshaft seals or valve cover gasket is the source. Using the flashlight, look closely for any especially wet or shiny spots, possible sources or clues to the origin of the oil leak. step 3: add uv dye to your engine. once you have located any possible areas that could be the source of the leak, pour your automotive grade uv dye into your engine via the oil filler cap. All purpose degreaser. step 1: use the degreaser. spray a little all purpose degreaser on the area you see oil. allow it to penetrate for a few minutes and then wipe it off. step 2: check for a leak. start the engine and let it run for a few minutes. check to see if you can spot a leak below the car.
Trying To Spot Oil Leak With Uv Dye Youtube Using the flashlight, look closely for any especially wet or shiny spots, possible sources or clues to the origin of the oil leak. step 3: add uv dye to your engine. once you have located any possible areas that could be the source of the leak, pour your automotive grade uv dye into your engine via the oil filler cap. All purpose degreaser. step 1: use the degreaser. spray a little all purpose degreaser on the area you see oil. allow it to penetrate for a few minutes and then wipe it off. step 2: check for a leak. start the engine and let it run for a few minutes. check to see if you can spot a leak below the car. Common causes of leaks include: high pressures. extreme temperatures. loosened fittings as a result of vibration. seal swell, shrinkage or wear. the chart below is used to estimate the cost of leakage as analyzed by drops per second. so, when you identify a leak, it is prudent to stop the leakage at its source. The dye is totally harmless. its best to get a good uv light and check it in the dark or low light, the dye streak will show right up. you can get dye for engine oil, transmission ps fluid, coolant (dexccol need a special dye), a c systems and fuel. once you use it and see the results you will wonder why you didn't try this before. x.
Comments are closed.