How To Clean A Pool Filter Cartridge Inyopools Follow these steps to clean a sand pool filter: backwash the filter for 3 5 minutes. turn off your pool pump and set it to “filter”. open the pump lid, and pour sand filter cleaner into the strainer basket. follow the manufacturer’s instructions for the correct quantity of cleaner. Remove the pump’s strainer lid and our sand filter cleaner into the strainer basket. then, replace the pump lid. turn the pump on for about 15 seconds, just long enough to transfer the cleaner from the pump to the filter. turn off the pump, and leave it off for at least 8 hours, or overnight.
How To Clean A Pool Filter Cartridge Leslie S Youtube Turn the pump back on and run the filter on "rinse" for 1 2 minutes to clear out dirty water and reset the sand. [8] 2. return to the "filter" setting. after rinsing is complete, turn the pump off once again, and switch your valve to the standard "filter" setting. turn you pump back on and allow it to run normally. Turn the pump back on and rinse for 30 45 seconds. turn the pump back off. turn the valve on the filter to the “filter” setting. once or twice a year, remove the filter basket during this step and pour in the sand filter cleaner. turn on the pump just long enough to move the cleaner into the sand. Turn the valve to filter and take off the pump’s strainer lid. pour your sand filter cleaner into the strainer basket, putting the lid back on. turn the pump on for as long as it takes for the cleaner to transfer from the pump into the filter. this typically takes around 15 seconds. turn your pump off. Step 1: backwash the filtration system. sand and de filtration systems have a backwash feature that makes it easy to clean the filter. check the top of the multi port valve to find the “backwash.
How To Clean Your Swimming Pool A Step By Step Guide Turn the valve to filter and take off the pump’s strainer lid. pour your sand filter cleaner into the strainer basket, putting the lid back on. turn the pump on for as long as it takes for the cleaner to transfer from the pump into the filter. this typically takes around 15 seconds. turn your pump off. Step 1: backwash the filtration system. sand and de filtration systems have a backwash feature that makes it easy to clean the filter. check the top of the multi port valve to find the “backwash. Rinse and filter. move the multiport to “rinse” and turn the pump on for three seconds, then shut it off. next, move the multiport to “filter.”. close the backwash separation tank valve, if present. add a filter cleaning solution and leave the pump off overnight or at least eight hours. How often to brush your pool. at least twice a week, brush the walls, ladders, and corners of your pool. be sure to get into every nook and cranny possible to brush away any lurking algae formations. brushing will push the algae into the water, making it easier for chlorine or other sanitizers to kill it.
Comments are closed.