How To Change Your Water Pump Youtube Mount the new gasket or seal in place on the water pump. install the water pump and gasket. then use a torque wrench to tighten the water pump mounting bolts to the manufacturer’s specification. install the water pump pulley. then install the pulley retaining bolts by hand (do not tighten the bolts down at this time). Scotty kilmer, mechanic for the last 46 years, shows how to change a water pump on your car. water pump location, inspection, diagnosis, removal and replacem.
How To Replace Your Water Pump Youtube Autozone autozone parts timing belt n 8gcts?newymme=true in the fourth installment of the autozone complete car care timing belt series, b. Remove the radiator cap and empty the radiator by disengaging the valve under the front passenger's side. 6. remove the fan belt, if one is present. 7. detach the radiator hoses. 8. unbolt the fan shroud, found on the water pump's shaft. 9. remove the fan shroud. 3. remove the timing belt, timing belt tensioner, and pulleys. 4. unbolt the water pump from the engine. 5. make sure the metal surface of the engine is clean before installing new water pump. 6. 5. remove the old water pump. pay attention to the length of the bolts as you remove them because they might not all be the same. 6. use a scraper or brillo pad to make sure all surfaces, including the pump mounting surfaces, are clean and free of old water pump gasket material and adhesives before reassembly.
How To Replace Your Water Pump Detailed Ep21 Youtube 3. remove the timing belt, timing belt tensioner, and pulleys. 4. unbolt the water pump from the engine. 5. make sure the metal surface of the engine is clean before installing new water pump. 6. 5. remove the old water pump. pay attention to the length of the bolts as you remove them because they might not all be the same. 6. use a scraper or brillo pad to make sure all surfaces, including the pump mounting surfaces, are clean and free of old water pump gasket material and adhesives before reassembly. Reconnect all hoses to the water pump, and replace any brackets or accessories removed previously. replace the fan, pulley, radiator shroud (if so equipped) and drive belts. adjust all belts to the proper tension, and fill the system with a 50 50 antifreeze water mixture. reconnect the battery ground cable, start the vehicle and check for leaks. Check the water pump pulley. find the round part at the front of your water pump that the belt is around. attempt to rock the pulley back and forth. if it seems to be loose, it may be time to replace it, because the bearing is going bad. [2] 4. listen to your car. start your car's engine with the hood up.
Comments are closed.