Front Subframe Front Subframe Assembly Remove And Replace Remove the drive unit sling from the gantry hook. move the subframe lifting tool to a working area. position the front drive unit harness on the front subframe, and then install the clips that attach the front drive unit harness to the subframe. figure 4. other assemblies hidden for clarity. Remove the lh and rh front wheels. see wheel assembly (remove and install) . remove the front fascia. see fascia front (remove and replace) . remove the bolts (x2) that attach the front end carrier to the lh front subframe crash can assembly, then repeat this step on the rh side of the vehicle. raise the vehicle.
Subframe Assembly Front Rwd Remove And Replace Remove the hose plugs, and then install the battery coolant heater to coolant pump 2 hose at the rear of the front subframe assembly and secure it with the hose clamp. remove the hose plug, and then secure the hose clip and the fir tree clip that attach the coolant hose to the radiator inlet. remove the coolant drain container from under the. Remove and discard the front subframe front mounting bolts. 22. lower the subframe assembly from the vehicle. installation all vehicles 1. using the powertrain lift table, raise the subframe into the installed position. 2. note: rh shown, lh similar. install the 2 new front subframe front mounting bolts. tighten to 200 nm (148 lb ft). On each side of the vehicle, mark a witness line on the subframe cam to aid installation, then remove the bolts that secure the front and rear lower control arms to the subframe (torque 130 nm). remove the bolt that secures the lower intermediate shaft to the steering rack (torque 49 nm). Remove battery coolant pump 1 from the bracket on the subframe and set the pump aside. on each side of the vehicle, remove the bolt (torque 20 nm) that secures the condenser fan module bracket to the subframe. install the front subframe jig onto the subframe fixture. install the locating pins into the forward holes on the subframe fixture.
Front Subframe Front Subframe Assembly Remove And Replace On each side of the vehicle, mark a witness line on the subframe cam to aid installation, then remove the bolts that secure the front and rear lower control arms to the subframe (torque 130 nm). remove the bolt that secures the lower intermediate shaft to the steering rack (torque 49 nm). Remove battery coolant pump 1 from the bracket on the subframe and set the pump aside. on each side of the vehicle, remove the bolt (torque 20 nm) that secures the condenser fan module bracket to the subframe. install the front subframe jig onto the subframe fixture. install the locating pins into the forward holes on the subframe fixture. Remove the bolts (x2) that attach the air suspension pump bracket to the front subframe (torque 5.5 nm). remove the rear bolt that attaches the radiator bypass 3 way coolant valve to the front subframe (torque 5 nm). the forward bolt was removed from above the vehicle in a prior step. Note: the tightening of the lh and rh crash can brackets occurs later during the installation of the front subframe assembly (remove and install). with an assistant, put the front stabilizer bar onto the front subframe, and then install new nuts to attach the front stabilizer bar to the front subframe.
Front Subframe Front Subframe Assembly Remove And Replace Remove the bolts (x2) that attach the air suspension pump bracket to the front subframe (torque 5.5 nm). remove the rear bolt that attaches the radiator bypass 3 way coolant valve to the front subframe (torque 5 nm). the forward bolt was removed from above the vehicle in a prior step. Note: the tightening of the lh and rh crash can brackets occurs later during the installation of the front subframe assembly (remove and install). with an assistant, put the front stabilizer bar onto the front subframe, and then install new nuts to attach the front stabilizer bar to the front subframe.
Subframe Assembly Front 3rd Generation Remove And Replace
Comments are closed.